Then, decide which conditions you wish to use for engine state detection.
If ticked, the condition is true when the configured DIN detects a constant
input voltage.
Default value: DIN4 enabled, other inputs disabled
If ticked, the condition is true after detecting movement.
Default value: Enabled
If ticked, the condition is true if the engine on state is provided by CAN
data. Active only when at least one CAN interface is turned on.
Default value: Disabled, inactive
If ticked, the condition is true if the power supply voltage is greater than
the entered value (in mV).
Default value: Disabled
If ticked, the condition is true if the RPM value provided by CAN data is
greater than the entered value. Active only when at least one CAN
interface is turned on.
Default value: Disabled, inactive
To Next Page
Loading...
