RUPTELA Trace5 - Page 33

32
· Custom -– configure parameters, to define how often the data
should be updated:
o Ignition off (s)– set how often the location should be
updated when the ignition is off. Default value: 3600 s
o Distance travelled (m)– set how far the vehicle
should travel to update the location. Default
value: 500 m
o Ignition on (s)– set how often the location should be
updated when the ignition is on. Default value: 60 s
o Angle turned (deg)– set how far the vehicle should
turn to update the location. Default value: 15 deg
Default value: Medium
Stationary filter
Discards inaccurate coordinates while the vehicle is not moving.
Default value: On
Active filter
Discards inaccurate coordinates by evaluating the vehicle’s movement
speed.
Default value: On
Acceleration threshold (m/s
2
)
Used in the calculation of the maximum possible distance. If a new
coordinate is too far away from the previous one, it will be discarded.
Default value: 19.6 m/s
2
Accuracy filter
Sets the coordinate accuracy. The higher the accuracy, the more
coordinates are filtered. We recommend using a lower accuracy, unless
you are sure the GNSS signal quality is excellent. Possible values:
· Off
· Low (recommended)
· Medium
· High
Default value: Off