RUPTELA Trace5 - Reset Command

40
sat.
The number of visible satellites. At least 4 satellites must be visible to
get an accurate GNSS signal.
hdop
The current HDOP (signal accuracy) level. If the HDOP level is above
3.5, the GNSS signal is inaccurate.
state
The current GNSS state. Possible values:
1 – GNSS module off
2 – GNSS module on, no fix
3 – GNSS module on, fix acquired
4 – GNSS module not responding
5 – GNSS module is in sleep mode
6 – GNSS module disabled

reset
When all else fails, use the reset SMS command to restart the device. Configuration parameters will not be
lost.
Command syntax: password reset
Response example: Resetting device
