EasyManua.ls Logo

Ruroc Shockwave - ATTENTION; Helmet Modification and Installation

Ruroc Shockwave
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN.
ATTENTION
1. Installing equipment on the helmet is a modication of the helmet, which
may cause the helmet’s warranty to fail or hinder the helmet’s function. This
may cause danger in the event of accidents. 2. Before using the Shockwave
bluetooth system, please ensure that the product is rmly and correctly
installed in the helmet. If the product falls o during riding, it may cause
injury or accident. 3. To ensure riding safety, please use this product
carefully to avoid serious harm, death or injury. 4. In order to maximise the
communication distance, aim to use the system in an open place with clear
line of sight. 5. In the case of rain, please keep the device facing down, the
USB rubber plug tightly installed during use to prevent water from entering
the device. 6. The product contains a 3.7V/500mAh battery that will change
with temperature. When the battery is used at low ambient temperature
(below 0ºC), the battery life of the product may be temporarily reduced, with
a risk of permanent damage. 7. If the electronic function fails, please power
o and try again.
Bluetooth Version: 5.0
Support: Qualcomm®aptX™,CVc noise cancellation technology 3D
sound eects
Electric Parameter: DC 5V/1A
Audio encoding format: SBC, AAC & aptX
Driver-Pillion Intercom communication distance: up to 100 meters
Bluetooth headset communication distance: up to 10 meters
Charging interface: USB Type-C
Permissible Operating Temperature: -20~50ºC
Recommended Storage Temperature: -5~30ºC
Waterproof rating: IP64

Related product manuals