Ruroc Shockwave - SHOCKWAVE BASICS; Power, Charging, and Reset; BLUETOOTH CONNECTION; Pairing and Connecting Devices

EN.
SHOCKWAVE BASICS BLUETOOTH
CONNECTION
1. When connecting the Shockwave system to your device for the first
time*, hold the ON button** for 3 seconds until you hear ‘Pairing’
2. The red [F] and blue [E] LED lights will begin to flash alternatively as
the Shockwave looks for a connection to a device
3. From your device, enter the Bluetooth® menu and select ‘Ruroc
Atlas Shockwave Audio’
4. You will hear the message ‘Connected’ to confirm connection,
and the blue [E] LED will flash once periodically while the devices
remain paired
*Your Shockwave will automatically connect to a previously connected device
(within range) when powered on.
**If the unit is already on, pressing the Volume down [A] and Volume up [G]
buttons together for 5 seconds will put the unit into pairing mode.
Turn On Press the centre button [C] for 1-2 seconds to switch
on the Shockwave system, you will hear a “Power On”
message
Turn O
Turn o manually by holding the centre button [C] for 3
seconds, you will hear a “Power O” message. The unit
will turn o automatically after 5 minutes of inactivity
Charging Plug the USB-C cable into the charging port [B], the red
[F] LED will light up indicating that the unit is charging
Charged When the device is fully charged the red [F] LED will go
out and the blue [E] LED will light up
Reboot Connect with the USB-C cable to a data or power source.
Once the red [F] LED comes on the reboot is complete.
Reset ‘Forget All Devices’ by pressing the centre button [C] for
6 seconds, you will hear ‘All pairing information cleared”