Don’t purée the fruit. Remove stems, seeds, and stones, then either crush it with a potato masher, or cut
it up. Jam should have bits of fruit in it. Don’t worry about tiny seeds (strawberries, raspberries, etc.).
Dough and Pizza Dough
With these programs you can use the Breadman™ as a mixing/kneading machine, to save you work. It
won’t heat up during these programs.
When you remove the dough from the machine, punch it back then cover and let it rest for ten minutes or
so before cutting/shaping.
Bake Only
This program uses the Breadman™ as an oven. It won’t mix, rise, or anything else, it just bakes then
goes into “Keep Warm” mode for an hour. Use this program to bake dough you’ve made earlier, or ready-
prepared dough from the supermarket.
Most products will expand while baking – leave room for this when you fill the loaf tin.
a) Use the Select button to bring the pointer down to the Bake Only program. The display will show 1:30
and a small clock symbol.
b) Use the arrow buttons to decrease d or increase u the time. You can set any time between 15 minutes
and 2 hours, in 1 minute steps.
c) If you keep your finger on the buttons, the display jumps 10 minutes at a time.
d) When the display shows the time you want, press the Program Time/Temp button. The
display will change to 300°F (degrees).
e) Use the arrow buttons to decrease
or increase the temperature. You can set the display from
200°F to 375°F in 5 degree steps. That’s equivalent to a range of 93°C to 190°C. There’s a conversion
table on page 27.
f) You can press the Program Time/Temp button to switch between time and temperature, till you’ve got
the combination you want.
g) Press Start.
Using packet bread mix
If you use packet bread mix, don’t use more than 500g of mix at a time.
Follow the instructions accompanying the bread mix.
Advanced baking techniques – add to recipe book
Pause
This allows you to intervene during the program cycle.
Press and hold the Pause button for 2 seconds to suspend the program for up to ten minutes.
Press Start to resume the program cycle. If you don’t press Start, the program will resume automatically
after ten minutes.
To Next Page
Loading...
