4
C FILLING
1 Remove the carafe from the hotplate.
2 Use the grip to open the lid, and expose the reservoir.
3 Fill with at least 2 cups of water, but not above the max mark.
4 Put filter-ground coffee into the filter. The amount will vary with
the type of coffee and individual taste, but we suggest two
rounded teaspoons per cup of water.
5 Close the lid.
6 Replace the carafe on the hotplate.
C SWITCH ON
7 Put the plug into the power socket
a) everything will light up, beep, and go out
b) the display will flash for a few seconds
c) it’ll beep, stop flashing, and settle at 12:00 AM
Y BREW STRENGTH
8 If you’re brewing less than 5 cups of coffee, press the Y button.
It slows the brewing process, so your coffee will have the same
strength as coffee from a full carafe.
9 The Y light will glow and a “smiley” mug will show in the
display.
10 Pressing the Y button again will deactivate the feature, the Y
light will go out, and the “smiley” mug will disappear.
C COFFEE NOW
11 Press the X button. The X light will glow.
12 Shortly afterwards, coffee will start to drip into the carafe.
C KEEP WARM
13 When it has finished brewing, it’ll go into keep warm mode.
14 The X light will flash, and the hotplate will keep the carafe
warm for about 2 hours, then it’ll shut off.
15 The display will change to 0:00, then count up, to show how long
the coffee has been sitting.
16 Chemical changes in the coffee liquor start to affect the flavour
after about an hour.
To Next Page
Loading...
