Russell Hobbs 25600

4
BEFORE USING FOR THE FIRST TIME
• Remove labels, stickers and packaging from the appliance.
• Read all instructions and warnings.
IMPORTANT INFORMATION
• For best performance, we recommend using distilled, puried or ltered water in your
steamer. Tap water contains minerals that can build up inside your steamer over time and
reduce its eciency or even cause damage.
• Never use perfumes, oils or other additives.
• Always check the garment’s care label before steaming, and always test fabrics for
colourfastness in an inconspicuous area. Steamers are not recommended for use on leather,
suede, vinyl, plastic, or other materials that are sensitive to steam.
• During use the steamer and accessories will become HOT. Never try to t or remove
attachments while still hot.
• After preheating, prime the water pump by holding the steam trigger until steam forms.
• It is normal to feel or hear the water pump inside the device. It may become louder when
the water level in the tank is low. Check and rell the tank when required.
• Small amounts of dripping might occur during use. If excessive, your steamer needs time to
get back up to full temperature. Just allow the steamer a minute to reheat.
• Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always
allow the clothing to cool for about 5 minutes before wearing.
ATTACHMENTS
Your steamer has three attachments:
Lint attachment
Use on garments labelled k l that allow the use of steam.
Tip: The pad on the attachment helps remove lint, hair, and animal
fur.
Delicate attachment
Use on garments labelled j that allow the use of steam.
Tip: For items with printing/embellishment, turn the garment inside
out to avoid damage to sensitive areas.
Upholstery attachment Use to sanitise and refresh bedding, mattresses, curtains, plush toys,
furniture, and hard surfaces (such as worktops or desks that are not
heat sensitive).
Always test for colourfastness and heat sensitivity on an
inconspicuous area.
Fitting/Removing (Fig. A)
1. Make sure that the steamer and attachment are cool.
2. Hook the top of the attachment over the top edge of the steamer.
3. Click the bottom edge into place.
4. Remove the attachment using the tab. When removing the attachment, watch out for
condensation that may have built up during use.