Russell Hobbs 25600

6
Cleaning attachments
• Lint attachment: Wipe with damp cloth to clean.
• Delicate attachment: Wash with cold water and small amounts of a gentle cleanser if
needed. The fabric cannot be removed.
• Upholstery attachment: The fabric can be removed and hand washed with cold water and a
gentle cleanser.
TROUBLESHOOTING
Problem Possible Cause Solution
The steamer is plugged in but
not heating.
The auto shut-o has
activated.
Press the steam trigger or
press the power button to
activate the steamer.
Not enough steam or no
steam is coming out of the
steamer.
The steamer is not heated to
full temperature.
Always allow steamer to
preheat at least 45 seconds, or
until the power button light
stops ashing.
There is not enough water in
the water tank.
Fill the water tank.
The water pump hasn’t been
primed.
After preheating, always
prime the water pump by
holding the steam trigger
until steam forms.
Discoloured water is coming
through the holes and
staining the fabric.
Residue has built up in the
water tank.
Empty the water tank after
each use. Only use distilled,
ltered, or puried water.
Perfumed or scented
additives were used.
Never use perfumed or
scented additives.
Steamer is leaking or spitting. Steamer is not hot enough. Allow the steamer to heat for
about 45 seconds.
Water tank is running low. Fill the water tank.