Russell Hobbs 26082 - Russell Hobbs 26081 Kettle: Operation Guide; Kettle First Time Use and Filling; Using Your Russell Hobbs 26081 Kettle; Kettle Boil Dry Protection

4
BEFORE USING FOR THE FIRST TIME
Fill to max, boil, discard the water, then rinse. Do this twice to remove any manufacturing dust,
etc.
FILLING
1. Remove the lid.
2. Fill with at least 1 cup of water, but not above max. Never ll the kettle above the MAX
marking. Overlling can cause a hazardous situation and possible damage to the kettle.
3. Ret the lid.
• You must make sure that the lter in the lid is aligned with the spout when tting the lid. If
you don’t do this, water will build up behind the lid because it cannot be poured out
normally and this may cause the lid to come o unexpectedly.
USING YOUR KETTLE
1. Put the stand on a stable, level surface.
2. Plug the stand into the wall socket.
3. Put the kettle on the stand.
4. Move the switch to I.
5. The light will come on and the kettle will start to heat.
6. When the water boils the kettle will switch o.
7. To switch o manually, move the switch to O, or simply lift the kettle o the stand.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused
by the steam used to switch your kettle o automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it o. If this happens,
unplug your kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle
to boil dry will shorten the life of the element.