13
CAUTION: when brewing cappuccino or latte, you will need to adjust the frothing tube lever in
order to position the froth milk dispensing tube inside the selected cup.
TURNING/ SWITCHING THE UNIT “ON”
Make sure that the coffee maker is plugged into the appropriate power outlet.
Turn unit ON “I”.
The three control panel lights will start flashing whilst the coffee maker is heating and until
the water reaches the perfect temperature. Once these lights turn to a solid/uninterrupted
state then the coffee maker is ready to use.
SELECT THE DESIRED FUNCTION
PREPARING ESPRESSO
1. Press the Espresso button once to brew one single shot.
2. OR press the Espresso button twice to brew a double shot.
3. OR press and hold the Espresso button for 3 seconds to customize the brewing amount to
your preference. When done, press the Espresso button once again to stop it.
4. The coffee maker will start brewing the espresso according to your selection. The coffee
maker will turn to standby mode automatically and the lights will become solid indicating that
the cycle has been completed. Your delicious espresso is ready to be enjoyed.
NOTE: Wipe the froth tube immediately after the cycle has completed to keep your appliance in a
clean and hygienic condition. Be very careful when doing this and ensure that it is only done once
the cycle has completed and the coffee cup removed, as the steam may scald you.
To Next Page
Loading...
