6
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
• Move the steam control to
no steam.
• Select the required temperature.
• Wait till the temperature light stops ashing, then start ironing.
VERTICAL STEAM
Vertical steaming removes wrinkles from hanging clothes, hanging
curtains, and furnishing fabrics.
• Check that there is water in the tank.
• Set the temperature control to max (red). Set the steam control
to
.
• Wait till the light stops ashing.
• Check that there is nothing behind the fabric that may be
damaged by the steam or heat.
• Check that pockets, turn-ups, and cuffs are empty.
• Hold the iron, with the soleplate vertical, close to (but not
touching) the fabric.
• Press the
burst of steam button. You may have to press it 2 or 3 times to pump water
through the system.
• Leave 4 seconds between bursts, to allow the temperature to recover.
AFTER USE
• Unplug the iron.
• Lift the cover of the water inlet to the side to open it.
• Hold the iron over a sink, turn it upside down, and drain the
water from the tank.
CAUTION: The water may be hot.
• Sit the iron on its heel.
• Leave it to cool down completely.
• When it is cold, wipe off any moisture, and close the water inlet
cover.
• Store the iron on its heel, to avoid corrosion and damage to the
soleplate.
To Next Page
Loading...
