6
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
• Move the steam control to
no steam.
• Set the temperature control dial to the desired setting.
• Wait until the light switches off, then commence ironing.
VERTICAL STEAM
Vertical steaming removes wrinkles from hanging clothes, hanging
curtains, and furnishing fabrics.
• Check that there is water in the tank.
• Turn the temperature control dial to ‘max’.
• Wait until the light switches off.
• Check that there is nothing behind the fabric that may be
damaged by the steam or heat.
• Check that pockets, turn-ups, and cuffs are empty.
• Hold the iron, with the soleplate vertical, close to (but not
touching) the fabric.
• Press the
burst of steam button. You may have to press it 2 or 3 times to pump water
through the system.
• Leave 4 seconds between bursts, to allow the temperature to recover.
AFTER USE
• Turn the temperature control dial to ‘synthetic’, move the steam
control to
no steam.
• Unplug the iron.
• Lift the cover of the water inlet to the side to open it.
• Hold the iron over a sink, turn it upside down, and drain the
water from the tank.
CAUTION: The water may be hot.
• Sit the iron on its heel.
• Leave it to cool down completely.
• When it is cold, wipe off any moisture, and close the water inlet cover.
• Store the iron on its heel, to avoid corrosion and damage to the soleplate.
steam control
n
y
l
o
n
w
o
o
l
c
o
t
t
o
n
m
a
x
m
i
n
steam control
n
y
l
o
n
w
o
o
l
c
o
t
t
o
n
m
a
x
m
i
n
To Next Page
Loading...
