6
PREPARATION
• Check for textile care symbols ( ) on items to be ironed.
• Iron fabrics needing low temperatures
rst, then those that need medium
temperatures
, and nish with those needing high temperatures .
TEMPERATURE SETTING GUIDE
LABEL MARKING TEMPERATURE DOT SETTING
cool - nylon, acrylics, polyester, synthetics •
warm - wool, polyester mixtures, silk • •
hot - cotton, linen • • • / max
do not iron
NOTE: If the instructions on the fabric label differ from this guide, follow the instructions on the label.
FILLING
You may use the iron with tap-water, however if you live in a hard water area, you should use
distilled water (not chemically descaled or softened water).
If you buy distilled water, check it is marked as suitable for use in irons.
• Unplug the iron from the wall power outlet.
• Set the steam control to
no steam.
• Lift the cover of the water inlet to the side to open it.
• Hold the iron with the soleplate horizontal.
• Fill slowly, to let the air in the tank escape, otherwise you will
cause an air lock and the water may overow.
• Do not ll past ‘max’, or water may spill whilst in use.
• Wipe up any spillage.
SWITCHING ON
• Turn the temperature control dial to 'nylon' and set the steam control to no steam.
• Sit the iron on its heel.
• Plug the power cord into the wall power outlet, and switch it on. The red temperature indicator
light will illuminate.
• Turn the temperature control dial to bring the desired setting on the dial
next to the
mark on the tank.
• When the iron reaches the set temperature, the light will switch off.
• The temperature indicator light will cycle ON and OFF as the thermostat operates to maintain
temperature.
AUTO SHUT-OFF
• If the iron is motionless, the element will switch off after 30 seconds if lying on its soleplate or
on its side and 8 minutes if it is sitting upright.
• The red light will blink continuously until you move the iron.
• To switch on again, lift up the iron, tilt it forward and then sit it upright.
• No settings are lost during auto shut-off
MAX
C
MAX
To Next Page
Loading...
