26. Do not let the deep fryer heat without oil in it, or with the oil below the Min level. This will
cause the thermal cut-off to switch the unit off, and may damage the unit.
27. Do not connect the deep fryer to the power supply without oil in the unit.
PARTS DIAGRAM
OPERATING INSTRUCTIONS
NOTE: Do not use this product to heat water. Never plug the control panel into a wall
socket if it is not installed in the outer housing.
• Clean the unit thoroughly before using for the first time.
• Place the deep fryer on a stable flat surface. Fill the enamel bowl (oil pot) with fresh cooking
oil. Ensure the oil is above the Min mark and below the Max mark, seen on the inside of the
bowl.
• Plug the heater into the wall socket and switch on the wall socket. The digital panel will light
up and emit a beep.
To Next Page
Loading...
Need help?
General
