Russell Hobbs RH1250TW

FAULT
POSSIBLE CAUSE
REMOVING METHODS
Excessive foam is formed in the
detergent drawer.
Excessive amount of detergent
used.
Press on Start/Pause button.
To eliminate foam formation,
mix a spoon of softener with
half litre of water, and pour the
mixture in the detergent drawer.
After 5-10 minutes, press on
Start/Pause button again. For
next washing operation, decide
the dose of detergent as
required.
Wrong detergent used.
Use detergents produced only
for automatic washing
machines in your machine.
settled unevenly.
recommended and settle
the laundry in the machine
evenly.
Your machine rests on a
hard surface.
Prevent your machine from
resting on hard surfaces.
FAULT
POSSIBLE CAUSE
REMOVING METHODS
Your machine does not start.
It is not plugged in.
Plug machine in.
Fuse blown.
Replace the fuse.
Electricity cut-off.
Check mains power.
Start/pause button not
pressed.
Press on start/pause
button.
Programme knob ‘stop’
position.
Switch the programme
knob to the desired
position.
The machine door is not
completely closed.
Close the machine door.
Your machine does not
intake water.
Water tap is turned off.
Turn your faucet on.
Water inlet hose may be
twisted.
Check water inlet hose.
Water inlet hose
clogged.
Clean water inlet hose
filters.
Valve inlet filter clogged.
Clean the valve inlet
filters.
The machine door is not
completely closed.
Close the machine door.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-29-