Russell Hobbs RH1250TW

Questions and Answers

J
Jennifer HollowayJul 31, 2025
Why my Russell Hobbs Washer machine does not start?
- R
  Rodney NorrisJul 31, 2025
  Your Russell Hobbs washer might not start due to several reasons. Ensure it is properly plugged in and the fuse is not blown; replace the fuse if necessary. Check that there is no electricity cut-off. Make sure you've pressed the start/pause button and that the program knob is not in the ‘stop’ position; if it is, switch it to the desired position. Finally, ensure the machine door is completely closed.
G
Gregory HicksAug 5, 2025
What to do if my Russell Hobbs Washer machine does not discharge water?
- D
  donnablakeAug 5, 2025
  If your Russell Hobbs washer isn't discharging water, the discharging hose might be clogged or twisted, so check the discharging hose. Also, the pump filter could be clogged, so clean the pump filter. Another potential cause is that the laundry settled unevenly inside the machine; in this case, spread your laundry evenly.
J
Joe RodriguezAug 9, 2025
Why my Russell Hobbs Washer machine does not intake water?
- E
  esmithAug 10, 2025
  If your Russell Hobbs washer isn't taking in water, start by checking if the water tap is turned on; if not, turn your faucet on. The water inlet hose may be twisted or clogged, so check the water inlet hose and clean the water inlet hose filters. Also, the valve inlet filter might be clogged, so clean the valve inlet filters. Finally, ensure the machine door is completely closed.
P
Paul HenryAug 14, 2025
How to stop my Russell Hobbs Washer machine from vibrating?
- D
  Dr. Lisa HornAug 14, 2025
  To stop your Russell Hobbs washer from vibrating, ensure the feet of your machine have been adjusted. Also, check that the safety assembly fitted for transport has been disassembled.
R
rachel30Aug 20, 2025
What to do if there is excessive foam in the detergent drawer of my Russell Hobbs Washer?
- D
  Duane MartinezAug 20, 2025
  If you observe excessive foam in the detergent drawer of your Russell Hobbs washer, it could be due to using too much detergent or using the wrong type of detergent. Press the Start/Pause button. To eliminate foam formation, mix a spoon of softener with half a litre of water and pour the mixture into the detergent drawer. After 5-10 minutes, press the Start/Pause button again. Ensure you only use detergents specifically produced for automatic washing machines.
L
Lindsay FergusonAug 26, 2025
Why is my Russell Hobbs Washer machine washing result unsatisfactory?
- O
  osmithAug 26, 2025
  An unsatisfactory washing result from your Russell Hobbs washer may occur if the chosen program does not match the dirtiness of your laundry. Select the appropriate program for the correct dirtiness of your laundry. Also, the amount of detergent used might be insufficient, so adjust the amount of detergent based on the dirt level of your laundry. Finally, ensure you are not overloading the machine with laundry in excess of its maximum capacity.