Russell Hobbs RH8CTD600

Questions and Answers

J
John JohnsAug 10, 2025
What to do if the Russell Hobbs Washer clothes are not dry after normal drying time?
- S
  Sean BruceAug 11, 2025
  If your clothes aren't dry after the usual drying period, there are several things to check: * For small loads (under 1kg when wet), use the Time programme and set it to 60 minutes. * Ensure you've selected the appropriate programme for your load. * Make sure the water tank isn't full or nearly full. * Clean the lint/fluff filter, as a blocked filter restricts airflow. * Clear any obstructions from the condenser cover and unit; clean them if necessary. * Verify that the dryer is heating by checking if the area below the door on the left side feels warm after 10-15 minutes of the programme.
K
Karen JeffersonAug 21, 2025
What to do if my Russell Hobbs RH8CTD600 Washer machine does not work?
- W
  wesleyhawkinsAug 21, 2025
  If your Russell Hobbs Washer isn't working, try the following checks before contacting a service engineer: 1. Ensure the drum has the correct weight load. 2. Verify the machine is plugged in, the power is switched on, and there's electricity supply. 3. Confirm the door is properly closed and the machine is switched on (start button pressed, if fitted). 4. Check if the child lock is activated. 5. Inspect the fuse in the plug.
L
lauraschultzAug 31, 2025
Why has my laundry shrunk in my Russell Hobbs Washer?
- E
  Emily HollandAug 31, 2025
  Laundry may shrink, felt, or deteriorate if you haven't used the correct programme for the type of laundry you're drying. Ensure you only dry items suitable for machine drying, checking the labels on your clothes beforehand. Select a programme and dryness level appropriate for the laundry type.

The Russell Hobbs 8kg Condenser Tumble Dryer (Model number: RH8CTD600(B)(R)) is a domestic appliance designed for drying laundry. It operates by removing humidity through two separate airflows: air recirculates inside the machine, is heated, and then passes through damp clothes to pick up moisture. This damp air is then passed through a condenser, where it meets room air flowing in the opposite direction, causing the moisture to condense into water. This water is then either pumped to a water tank or drained out through a hose.

Important Technical Specifications:

Brand: Russell Hobbs
Model: RH8CTD600(B)(R)
Type of dryer: Condenser
Energy efficiency rating: B
Capacity: 8 kg
Weight: 40.5 kg
Dimensions (H x W x D): 84.5 cm x 59.5 cm x 61.5 cm
Energy consumption: 561.0 kWh per year (based on 160 drying cycles of the standard cotton programme at full and partial load, and low-power modes).
Automatic or non-automatic: Automatic
EU Ecolabel: N/A
Energy consumption (standard cotton programme): 4.74 kWh (full load), 2.56 kWh (partial load)
Power consumption (off-mode Po): 0.28 W
Power consumption (left-on mode Pl): 1.72 W
Duration of left-on mode: 10 min
Weighted programme time (standard cotton programme): 112 min (full and partial load)
Programme time (standard cotton programme): 140 min (full load), 90 min (partial load)
Condensation efficiency class: B (on a scale from G to A)
Average condensation efficiency (standard cotton programme): 80.1% (full load), 80.1% (partial load)
Weighted condensation efficiency (standard cotton programme): 80.1% (full and partial load)
Sound power level (standard cotton programme at full load): 69 dB
Operating environment: Best performance between 5°C and 35°C.
Electrical connection: AC230V ~ 50HZ, fitted with a 13A plug complying with BS1363. Must be earthed.

Usage Features:

The dryer features a control panel with several buttons and indicators:

On/Off Button: Powers the dryer on and off.
Programme Dial: Allows selection from 12 drying programmes, detailed in the programme table. Programmes include Cotton (Damp, Iron, Standard, Extra), Synthetics (Damp, Standard, Extra), Delicate, Time, Cool, Quick, and Refresh.
Gentle Button & Indicator: Reduces the drying temperature. The indicator lights up when activated. Must be selected before starting the cycle.
Anti-crease Button & Indicator: Reduces creasing of clothes. The indicator lights up when activated. Must be selected before starting the cycle.
Start/Pause Button: Initiates or pauses the drying cycle. If the door is opened mid-cycle, the dryer stops, and this button must be pressed to resume.
Time Button: Used with the "Time" programme to select a drying duration from 20 to 60 minutes. Must be selected before pressing start.
Delay Button: Delays the start of a programme by 1 to 24 hours. The delay time is shown on the LED display, and the delay icon lights up. Must be selected before pressing start.
LED Display: Shows approximate programme duration, countdown time, delayed start time, error codes, warning symbols, and child lock activation.
Drying Status Indicators: Show the current stage of the drying process (drying, ironing, normal, airing).
Water Tank & Cover: Located at the top left, collects condensed water. Should be emptied after every drying cycle for optimum efficiency.

Sensor Controlled Drying: For Cotton, Synthetic, Delicate, and Quick programmes, the appliance automatically detects moisture levels and adjusts drying time to achieve the selected dryness.

Child Lock: Activated by holding the "Gentle" and "Anti-crease" buttons simultaneously for 4 seconds after a cycle has started. This ignores all commands except power on/off. To deactivate, hold both buttons for another 4 seconds.

Safety Guidelines:

Intended for normal domestic use only.
Adequate ventilation must be provided.
Exhaust air must not be discharged into a flue used for other fumes.
Not recommended near ovens, cookers, or other heat sources.
Carpet must not obstruct ventilation openings at the base.
Do not stack on other appliances.
Electrical work must be done by a qualified person.
Clean the lint filter after each cycle to prevent extended drying times and safety cut-out trips.
Only recommended articles should be placed in the dryer.
Servicing should be done by an appointed service team with genuine parts.
Do not alter or modify the product.
Unplug after use and when not in use for long periods.
The rear of the dryer gets hot; ensure it's not accessible during operation and allow space for airflow.
Do not use two-way adaptors or extension leads.
Do not block air inlets.
Do not allow fluff to accumulate.
Do not exceed maximum load.
Do not dry items cleaned with anything other than water.
Do not dry dripping wet articles.
Do not use if damaged; contact helpline for repairs.
Supervise children and do not let them play with the appliance or packaging.
Plug must be connected to a properly grounded three-core socket.
If the supply cable is damaged, it must be replaced by the manufacturer.
Always hold the plug when disconnecting; do not pull the cord or disconnect with wet hands.
Do not overbend or put stress/heavy weights on the power cord.
Do not install near fire, heat sources, or in damp environments.
Do not rest burning items on the appliance.
Do not use excessive or high-pressure water for cleaning.
Do not dry cushions, quilts, duvets, or items with oil-soaked fabric.
Remove all objects from pockets before use.
Ensure clothing is fully rinsed of detergent and stain remover.
Only dry machine-dryable fabrics, following garment labels.
Adjust feet for free air circulation, especially on carpeted floors.
Do not climb on or rest heavy objects/heating devices/liquid-containing items on the dryer.
Do not overload.
Do not stop the dryer before the cool-down cycle is finished.

Maintenance Features:

Cleaning the Fluff Filter: ALWAYS CLEAN THE FILTER AFTER EACH USE. Failure to do so can cause the safety cut-out to operate. Pull the filter upwards, open it, remove fluff by hand or with a soft brush, then close and slide back. Occasionally wash the filter in detergent solution with a soft brush. Replace damaged filters.
Emptying the Water Tank: The water tank should be emptied after every drying cycle. Fully remove the tank, empty its contents into a sink, clean, and replace.
Cleaning the Condenser: Recommended approximately every 3 months, or monthly if used frequently in autumn/winter. Open the condenser cover, remove lock rods, pull out the condenser, clean it thoroughly with water and a soft brush, then replace and close the cover.
Drain Hose Connection (Optional): The dryer can be connected directly to a wastewater drain or washbasin using the supplied drain hose, bypassing the need to empty the water tank. The hose should be attached at a maximum height of 100 cm, ensuring it is not pinched, bent, or folded.

Troubleshooting:

The manual provides solutions for common issues:

Clothes not dry after normal time: Check if load is less than 1kg (use 1hr programme), correct programme selected, water tank is not full, lint/fluff filter is clean, condenser unit is clear, and dryer is heating.
Machine does not work: Check correct weight load, electricity supply/plug/power switch, door closed, start button pressed, child lock activated, and fuse in the plug.
Laundry shrunk/felted/deteriorated: Ensure suitable programme and dryness level for laundry type.
Error Codes and Warnings:
- FILTER flashing: Water tank full or pump error. Empty tank; if still flashing, contact product care.
- TANK flashing: Airflow block. Clean fluff filter and condenser unit; check for obstructions.
- E30 flashing (with beep every 15 mins): Heater or thermostat error. Contact Product Care.
- E32 flashing (with beep every 15 mins): Humidity sensor error. Contact Product Care.
- E33 flashing (with beep every 15 mins): Temperature sensor error. Contact Product Care.
- E34 flashing (with beep every 15 mins): Temperature sensor error. Contact Product Care.

Door Reversal: The door cannot be reversed.

For customer services and spare parts, contact 0345 208 8750 (Monday - Friday 8am - 8pm, Saturday 9am - 1pm) or visit www.productcareuk.com. The product is guaranteed for 12 months from purchase, covering faulty materials or workmanship, subject to conditions including proper installation and domestic use. This warranty does not cover wear and tear, damage, misuse, or consumable parts. The appliance is marked with the 'Crossed-out wheelie bin Symbol', indicating it should not be disposed of with general household waste but through separate collection schemes for electrical/electronic/battery items.