is in place. Do not use this to switch the blender on and off.
7. Turn the switch to standby “0” / “OFF” before fitting/ removing the jugto/ from the
motor/ baseunit.
8. Turn the switch to standby “0” / “OFF” and wait until the blades come to a complete
stop before removing the lid from the jug, and before removing the jug from the motor/
baseunit.
9. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for theirsafety.
10. Children shouldbe supervisedtoensurethattheydonotplaywiththeappliance.
11. Do not use the blender without first locking the lid inplace.
12. Do not fill the jug with boiling liquids.Allow liquids to cool to a lukewarm temperature
before you put them in the jug. This type of temperature would be comfortable tothe
touch.
13. Do not put your hand into the jug, even when it has been removed for
cleaning – the blades are verysharp.
14. Do not come into contact with movingparts.
15. Do not put any other object (spoon, spatula, etc.) Into the jug while the blender
is pluggedin.
16. Do not leave the blender unattended when pluggedin.
17. Misuse of this appliance can result ininjury.
18. Position the motor unit on a dry, firm, level surface, close to a power socket
and out of reach ofchildren.
19. Route the mains lead so that it cannot be caught accidentally or trippedover.
20. Keep the blender and the mains lead away from hotplates, hobs andburners.
21. Store the blender away from direct sunlight and fluorescent light where
possible.
22. Do not let thejugoverflow. If liquid gets under the motor unit, it may be
sucked into the motor, damagingit.
23. Do not fill the jug above the MAX. mark. If you do, the contents may force the
lid off when you start the motor.
24. The blender is equipped with a powerful motor and therefore processes very
quickly. Due to its efficiency there is no need to run the motor for more than 2
minutes at atime.
To Next Page
Loading...
