4.
After using the blender, always move the switch into the „0‟ setting and remove the
mains plug from the poweroutlet.
5.
To remove the glass jug just turn it in an anti-clockwise direction and then lift itup.
Pulse Function
The pulse function will give you a short burst at maximum speed, regardless of the
current speed of the blades. The button is spring-loaded. When you stop pressing,
it will return to the speed the switch is pointingat.
Crushing Ice
Before using the blender to crush ice, make sure it is clean and rinse it out thoroughly.
Any remaining trace of detergent may affect the taste of the crushed ice and will flatten
any drink to which it has beenadded.
Ice cubes come in many shapes and sizes. You will have to experiment with the ice from
your ice cube tray. Insert a maximum of 8 ice cubes and add 15ml (1 tablespoon) of fresh
cold water. Put the lid on the blender and turn the control knob to “P”. While the unit is
blending, hold for 2 seconds and release for 2 seconds. Note that too much blending will
reduce the ice to liquid, too little will merely chip the edges/corners off the ice. Do not try to
crush ice without adding water to thejug.
Do not be tempted simply to increase the amount of ice and blend for longer – this
willnotwork.Toomuchicewillnevergiveyousatisfactoryresults.
Adding Ingredients
If you need to add ingredients while the blender is working, lift the cap off, pour
the new ingredients through the hole then replace the measuring cup. Make
sure that the added ingredients do not push the volume in the jug past the
MAX.mark.
To Next Page
Loading...
