6
AFTER USE
• Move the steam control to no steam.
• Unplug the iron.
• Open the water inlet cover.
• Hold the iron over a sink, turn it upside down, and drain the
water from the tank.
CAUTION: The water may be hot.
• Sit the iron on its heel.
• Leave it to cool down completely.
• When it is cold, wipe off any moisture, and close the water
inlet cover.
• Store the iron on its heel, to avoid corrosion and damage to the soleplate.
SELF CLEAN
To prevent residues building up, use the Self Clean button
regularly, at least monthly in normal water areas, more often in
hard water areas. You will require a sink or a large bowl to catch
the water coming out of the soleplate.
• Fill the tank to the ‘max’ level.
• Sit the iron on its heel.
• Plug the power cord into the wall power outlet, and switch it on.
• Hold the iron over the basin or bowl, with the soleplate facing
down.
• Move the steam control to self clean
and hold it there, whilst
gently moving the iron to and from over the sink or bowl.
CAUTION: Keep clear of the escaping water and steam.
• Water and steam will wash any residues through the soleplate, and into the sink or bowl.
• Release the self clean button when done.
• Empty the remaining water from the tank.
• Move the steam control to no steam.
• Unplug the iron, and sit the iron on its heel to cool.
• When it is cold, wipe off any moisture.
• Store the iron on its heel, to avoid corrosion and damage to the soleplate.
CLEANING
• Unplug the iron when not in use, and before cleaning.
• Allow the iron to cool down completely before cleaning and storing away.
• Wipe outer surfaces with a damp cloth. If necessary, use a little dishwashing liquid.
• Remove spots, or burnt on fabrics, by ironing a damp cotton or linen cloth with the iron hot.
Take care not to scratch the soleplate.
• Do not immerse the iron in water or any other liquid.
• Do not use harsh or abrasive cleaning agents, solvents or scourers on the soleplate as these
will damage the coating.
To Next Page
Loading...
