Do you have a question about the Russell Hobbs RHCTH1 and is the answer not in the manual?
Oscillation | Yes |
---|---|
Safety features | Overheat protection, tip-over switch |
Type | Ceramic |
Power | 2000W |
Heat settings | 2 |
Thermostat | Yes |
Cord Length | 1.5 meters |
Ensure product operates from a power source matching its voltage, frequency, and rating.
Inspect the unit for damage after unpacking before use.
Keep packing materials away from children to prevent hazards.
Ensure close supervision when children or infirm persons use the appliance.
Do not use damaged appliances; return for repair or replacement.
Turn off power before unplugging and ensure hands are dry to prevent shock.
Ensure the power cord is fully extended and not touching the heater.
Handle hot parts of the heater only by the provided handle.
Do not use the heater in areas with flammable substances like garages.
Keep combustible materials at least 1 metre away from the heater.
Arrange the cord to prevent tripping hazards and avoid covering it.
Avoid placing the heater on soft surfaces that could block openings.
Do not expose the product or cord to water or excessive moisture.
Do not use the product near water sources like bathtubs or pools.
Switch off and unplug the heater when not in use or before cleaning.
Regularly clean dust and fluff deposits to prevent overheating.
Avoid plugging other high-current appliances into the same circuit to prevent overload.
Avoid extension cords as they may overheat and cause a fire risk.
Use the appliance only for its intended purpose as described.
The appliance is strictly for indoor use only.
Never leave the appliance unattended while it is switched on.
Do not place objects on or block the heater's inlet/outlet openings.
Avoid positioning the heater directly below a power socket.
Using unrecommended accessories may cause hazards or void the warranty.
This product is designed exclusively for normal domestic or household use.
Follow manual instructions; unauthorized uses may void warranty or cause injury.
Place the appliance at least 90 cm from flammable objects and walls.
Use only approved extension cords suitable for the appliance's rating.
Position the cord to avoid tripping hazards and do not cover it.
Always pull the plug from the socket by the plug itself, not the cord.
Always disconnect the mains plug when the appliance is not in use.
Inspect the appliance for damages after removing packaging before first use.
Verify that all accessories are included as per the diagram before installation.
Ensure the heater is not installed directly under a socket and a power source is available.
Overview of the heater's parts including controls, outlets, and power cord.
Steps to unpack, place, plug in, and turn on the heater for the first time.
How to activate fan mode for air recirculation after powering on.
Instructions for selecting LOW (1200W) and HIGH (2400W) heat modes.
Procedure to turn off the heater using the ON/OFF button.
Note on the fan continuing to operate briefly after shutdown for cooling.
How to turn the oscillating function on and off using the SWING button.
Setting the operation timer from 1 to 8 hours and canceling it.
Adjusting desired temperature between 10-49°C and how the heater cycles.
Information on the remote control battery type (CR2025) and disposal recommendations.
The appliance has a safety device that shuts it down automatically in case of overheating.
The unit features a tip over switch; operation may be affected on thick carpets.
Instructions for cleaning the housing, air inlets, and outlets safely.
Store the heater in a dry place away from sunlight and dirt if not used for extended periods.
Details on Model No, Voltage, Frequency, and Output Power.
Details on the 1-year warranty for defects in quality and workmanship.
Steps for making a warranty claim, including proof of purchase and notification.
What is not covered by the warranty, such as misuse, damage, or unauthorized repairs.
Contact details for Home of Living Brands (Pty) Ltd for support and warranty.