1. Carefully remove the heater from the plastic bag and the carton.
2. Place the heater on a firm level surface,.
3. Setting the master button to “off”, on the base of the unit, plug the cord set into a 220-240v~AC
electrical outlet.
4. Plug in, Switch the power point to the on position then turn the master button on the heater to the on
position, the heater in standby mode, LED display room temperature, centigrade light, Please
wait 3 seconds, then start to operate any function, after 30 seconds, if no operation, light and LED
switch off.
5. Turn the heater ON by pressing the ON/OFF button “ ”. The unit is now in fan mode. This will
conduct recirculation of the room air.
To Next Page
Loading...
