Russell Hobbs RHFP750

Important: For your protection this appliance has an interlock system. The processor will not
operate unless the workbowl, cover and wide-mouth feed chute are properly locked in place.
• Place the wide-mouth feed chute on top of the cover with the small tab to the right of the
workbowl’s handle. Turn clockwise until it clicks into position in the handle.
• Insert the food pusher into the central tube of the wide mouth feed chute. Turn clockwise to
lock in place. The pusher is used to guide foods through the feed chute and can be
removed when adding liquid or additional foods while the processor is running.
• To remove, turn anticlockwise.
A
B
C
D
A
B
C
D
A
B
C
D
A
B
C
D
CONTROLS
• The controls are located on the front of the base (E).
• Press PULSE, HIGH or LOW to select a function (see directions below).
OFF/PULSE
• Processor should be stored in OFF position and unplugged when not in use.
• Use PULSE for short processing tasks. This lets you control the size and uniformity of foods
being chopped.
• The OFF/PULSE button must be pressed and held for the appliance to operate in PULSE
mode. When released, the appliance will stop.
• The motor of the processor will run as long as the OFF/PULSE button is held down.
• Press the button and then release to allow the blades to stop running and the food to fall to
the bottom of the workbowl.
• Pulsing gives better control when chopping, mincing, mixing and blending foods. You can
control the size of the foods, from coarse to fine.
HIGH AND LOW
• When either speed is selected, the processor will run continuously until the OFF/PULSE
button is pressed.
E