Door Reversal
2. Remove the hinge plug and plastic insert from the top of the door and fix
them to the opposite sides. For the RHGWC3SS-C & RHGWC3SS-C-LCK
you will need to remove the hinge stopper from the bottom of the door
and fix it to the opposite side of the door, ensuring it is fixed securely. For
all other versions this part is not applicable.
3. Remove the plastic insert on the left side of the cooler and fix it to the
opposite side.
4. Tilt the appliance no more than 45 degrees and remove the screw on the
left side of the cooler and set it aside. Then unscrew the 4 screws holding
the bottom door hinge in place, move it across to the opposite side and fix
it into position. Now fix the screw that you set aside to the right side of
the cooler.
5. Place the door back on to the bottom hinge, put the pin of the top hinge
into the top of the door and fix the hinge in to place by screwing it to the
top of the cabinet (use a spanner to tighten it if necessary). Ensure the
door is aligned horizontally and vertically so that the seals are closed on
all sides before finally tightening the top hinge.
Note: The appliance must now be upright for a minimum of 3 hours before
turning it on.
r6.2
For Customer Services, Spare Parts & Warranty Information please call 0845 209 7461
- 11 -
To Next Page
Loading...
Need help?
General
