6
WATER FILTER
Scale particles suspended in the water may give it a cloudy or greasy appearance. The lter will
prevent these particles going into your drink. Remove and clean the lter regularly.
CLEANING THE FILTER
• Check your hands are free from soap, hand cream, or anything which may leave a taint.
• Switch the power off and remove the plug from the wall power outlet.
• Allow the kettle to cool down fully.
• Press the lid release button to open the lid.
• Press the top of the lter down, to release the hook from the top of the spout.
Note Take care not to press on the mesh part of the filter – you may damage it.
• Lift the lter out of the kettle.
• Rinse the lter under a running tap whilst brushing with a soft brush.
• Rinse the kettle in case scale particles have fallen inside.
• Lower the lter into the kettle, and engage the bottom hook in the bottom of the spout.
• Push the top of the lter towards the spout, squeeze down on the middle hook and push
until it clicks under the top spout.
• Rell the kettle and close the lid.
CAUTION: Do not use the kettle without the filter in place – it may spit boiling water.
DISPOSAL/RECYCLING
Legislation in some localities mandates that e-waste (anything with a plug, battery or cord)
is disposed of through controlled recycling facilities and must not be disposed of in general
household waste. For more information about recycling of electrical and battery operated
appliances, please contact your local council or your local household waste disposal service.
To Next Page
Loading...
Need help?
General
