TURNTABLE INSTALLATION
Glass turntable(5), to be placed on the turntable support ring
a. Never place the glass turntable (5) upside down. The turntable
should never be restricted in movement.
b. Both glass turntable (5) and turntable support ring (4) must always
be used during cooking.
c. All food and containers of food should always be placed on the
glass turntable for cooking.
d. The glass turntable rotates clockwise or anti-clockwise randomly,
this is normal.
e. If glass turntable or turntable support ring cracks or breaks, contact
your nearest authorized service centre.
INSTALLING YOUR OVEN
Carefully remove all packaging materials and accessories.
.rood nekorb ro stned sa hcus egamad yna rof nevo eht enimaxE
Do not install if oven is damaged in any way.
Cabinet : Remove any protective film found on the outer surface.
Do not remove the light brown mica cover that is screwed onto the inner side of the microwave to
protect the magnetron.
INSTALLATION
1. Select a level surface that provides enough clear space for the intake and / or outlet ven
ts (see
fig.3).
A minimum clearance if 3.0 inch (7.5cm) is required between the oven and any adjacent wall. One
side must be clear.
1. Leave a minimum clearance of 12 inch (330) above the oven.
2. Do not remove the feet from the bottom of the oven.
3. Blocking the inside and/or outlet openings can damage the oven.
4. Place the oven as far away from radios and televisions as possible. Operation of microwave oven may cause interference to your radios and tele
visions
as possible. Operation of microwave oven may cause interference to your radio or televisions reception.
5. Plug your oven into a standard household outlet. Be sure the voltage and the frequency is the same as the voltage and the frequency on the rating
label.
Warning : Do not install microwave oven over a range cooktop or other heat-producing appliance. If installed above a heat producing appliance the
microwave oven could be damaged and the w
arranty would be void.
Warning : Do not install microwave oven in a cupboard.
(4)
(5)
To Next Page
Loading...
