Russell Hobbs RHMF10 - Assembling the Rear Guard; Assembling the Fan Blade; Assembling the Front Guard; Technical Specifications

Assembling!the!Rear!Guard!
1. Take&out&the&blade&cap&from&the&shaft&turning&it&clockwise.&
2. Take&out&the&rear&guard&mounting&nut&turning&it&anti-clockw ise.&
3. Insert&th e& rear& g u ard&into&th e& motor&matching& 3 & rods&o n & t h e& front&sid e& o f& t h e &motor&(the &h a n d le & w ill& d irect& &&
upwards)&to&3&holes&o f&the&rear&guard.&
4. Fasten&the&rear&guard&tightly&by&turning&the&guard&mounting&nut&clockwise.&
&
Assembling!the!Fan!Blade!
1. Insert&the &bla d e &to&th e&s h aft&a n d &e ns u re&the &p in&e nters&the&blade&slot.&
2. Tighten&the&blade&using&the&blade&cap&turning&anti-clockwise&in&the&direction”&TIGHT”&arrow&on&it.&
Note:&Proper&assembly&of&the&blade&is&of&great&importance.&Otherwise,&the&blade&spins&in&the&air&and&damages&
the&appliance.&
&
Assembling!the!Front!Guard!
1. Fix& the& front& guard& with& the& logo& in& the& upright& position& on& the& rear& guard.& M ake& sure& that& they& are&
connected&from&the&upper&side.&
2. Take&the&front&guard&rim&to&set&in&the&groove&and&fix&it&with&screwdriver.&
Note:&Do&not&operate&the&fan&without&assembling&the&guards&properly&and&tightly.&
&
&
&
Technical!Specifications!
&
Rated&Voltage:&230V~&
Rated&Frequency:&50Hz&
General&Power:&110W&
Max&Mist&Capacity:&200ml/h&
Blades&Size:&450mm&
Water&T ank&Capacity:&1500m&