MULTI-SECTION COOKING
At maximum, two sections can be set for multi-section cooking. In multi-section cooking, if
one section is weight defrosting, then weight defrosting shall be placed in the first section.
When the first stage finishes, a beep will be heard and the next stage will begin cooking.
Note: Auto cooking does not work in the multi-stage cooking.
Example: If you want to cook with 80% microwave power for 5 minutes + 60% microwave
power for 10 minutes. The cooking steps are as following:
1)
Press “TIME COOK” once, then press “5”,“0”,“0” to set the cooking time.
2)
Press “POWER” once, then press “8” to select 80% microwave power.
3)
Press “TIME COOK” once,then press “1”,“0”,“0”,“0” to set the cooking time.
4)
Press “POWER” once,then press “6” to select 60% microwave power.
5)
Press “START/+30 SEC” to start cooking.
MEMORY FUNCTION
You can programme up to 3 memory settings in the RHMO300 Family Microwave.
To set memory 1, press “0/MEMORY”. The LED will display 1.
To set memory 2, press “0/MEMORY” twice. The LED will display 2.
To set memory 3, press “0/MEMORY” three times. The LED will display 3.
Example: set the following procedure as memory 1, with 80% microwave power for 3
minutes and 20 seconds.
1) Press “0/MEMORY”. The LED will display 1.
2) Press “TIME COOK”, then press “3”,“2”,“0” in order. This represents 3 minutes and
20 seconds.
3) Press “POWER”. PL10 will display, then press 8 and PL8 will display. This represents
Power Level 8, or 80%.
4) Press “START/+30 SEC” to save the setting. If you press “START/+30SEC” again, the
memory function 1 will commence.
Note: If the electricity is cut off, the procedure will need to be reset by following the above
steps.
To Next Page
Loading...
