HOW TO CHOP IN THE WORKBOWL
The chopping blade is used to coarsely or finely chop, mince, mix and puree foods to a smooth
consistency.
• Lock workbowl into position (see Illustrations B and C).
• Hold chopping blade by centre shaft and insert onto centre post (F).
F
CAUTION: The blade attachments are very sharp. Use caution when handling and storing.
• Place food in workbowl.
• Place cover on workbowl and lock into place by rotating clockwise (see Illustration D).
• Place the wide-mouth feed chute and food pusher in place, turn to lock.
CAUTION: Never use your fingers to direct food through the chute.
• Select your desired speed (PULSE, LOW or HIGH).
NOTE: Process foods for no more than a few seconds at a time. Pulsing produces excellent
results and offers greater control.
• Food can be added while processor is running; remove food pusher and insert food through
the feed chute. Replace food pusher in chute.
CAUTION: Be sure chopping blade has completely stopped spinning before removing cover
from processor.
• Press the OFF/PULSE button and allow blades to stop revolving before removing cover.
Twist cover toward
to remove.
• Unlock workbowl by turning it anti-clockwise and lift off base.
NOTE: Remove bowl from appliance before removing blade to prevent food from leaking through
the centre opening of the bowl.
• Carefully remove chopping blade.
• Unplug appliance when not in use.
HELPFUL TIPS FOR CHOPPING AND BLENDING
• The processor works very quickly. Watch carefully to avoid over-processing foods.
• The PULSE button offers the best control and results. Process using PULSE in 5 second
intervals.
• For best results, process foods that are about the same size.
• The large workbowl has a capacity of 2L, and the small workbowl has a capacity of 500ml.
• Do not overload the bowl.
• Do not process more than 3 cups of liquid in the large workbowl at one time.
• Insert a funnel into the feed chute when adding ingredients such as, oil, flour and sugar.
• Do not process boiling liquids.
• To process meat, use no more than 2 cups of 20mm cubes in the large workbowl.
To Next Page
Loading...
