23
Change the program
A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the
section entitled " Detergent " ).
When you press the start/reset button more than 3 seconds, you can cancel the running the
programme and select other programmes (see the section entitled " Starting a wash cycle. . ." ).
The process lights shows the state of the dishwasher:
a) All of the process lights cut off --> stand by
b) One of the process lights on --> pause
c) One of the process lights blinking slowly --> run
d)some of the process lights fast blinking -->error
Washing cycles
Turning on the appliance
Starting the wash cycle
Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one (see the section entitled
Loading the Dishwasher ).
Pour in the detergent (see earlier sections for detail ).
Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
Close the door, press the power button. Then turn the program knob to select a desired wash
cycle.
Press the START/Reset button to start the machine.
and press Start/ button , the machin e w ill cont inue working after 1 0 secon ds.Rese t
I f you ope n the doo r , the mach ine will paus e. When you cl ose th e d oor ,during a wash cycle
When you open the door dur ing washing, the program lig ht will stop blinking and the
dishwasher will mooing every m inute unless the door is c losed.
To Next Page
Loading...
Need help?
General
