3
DESCRIPTION OF DEVICE
(1). Spray nozzle
(2). Filler door
(3). Steam dial
(4). Shot-steam button
(5). Spray button
(6). Auto shut o indication light
(7). Cord bushing
(8). Supply cord
(9). Sole Plate temperature
control light
(10). Transparent water tank
(11). Thermostat knob for
temperature regulation
(12). Self-cleaning button
(13). Sole Plate with steam vents
(14). Water measure
Anti-Calc System
A special resin lter inside the water reservoir softens the water and prevents scale
build-up in the plate. The resin lter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the “Zero-Calc” anti-calc
system ineective by altering its physicochemical characteristics. Do not use chemical
additives, scented substances or decalciers. Failure to comply with the above-
mentioned regulations leads to the loss of guarantee.
Anti-Drip System
With the anti-drip system, you can
perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave marks
or stains. In these cases, the Anti-drip system automatically activates to prevent
vaporization, so that you can iron the most delicate fabrics without risk of spoiling or
staining them.
Automatic Shut O
The automatic shut o device trips after the iron has been left for
approx. eight minutes
in the upright position or unused for approx. Thirty seconds in the horizontal position.
The light comes on to indicate that shut o has tripped. As soon as you move the iron,
the device turns o and the iron starts working again.
To Next Page
Loading...
