5
17 When the iron reaches the temperature you set, the thermostat
light will go off. It’ll then cycle on and off as the thermostat
operates to maintain the temperature.
S STEAM IRONING
18 Set the temperature control at S or higher (#2).
19 If you don’t, you’ll get water on your clothes, not steam.
20 Set the steam control at the setting you want, S = no steam, # =
high steam (#2).
21 Wait till the thermostat light goes out, then start ironing.
* SPRAY (#4)
, Test for water spotting on a hidden part of the fabric.
22 You may spray while dry or steam ironing.
23 Check that there’s water in the reservoir.
24 Lift the iron off the fabric, and aim the spray nozzle at the fabric.
25 Press the * button – you may have to press it 2 or 3 times to
pump water through the system.
S SHOT OF STEAM (#5)
26 This works while dry or steam ironing, if there’s water in the
reservoir, and the temperature is above S.
27 Check that there’s water in the reservoir.
28 Check that the temperature control is at S or higher.
29 Lift the iron off the fabric, and press the # button.
30 It may need 2 or 3 presses to pump water through the system.
31 Leave 4 seconds between shots, to let the temperature build up.
C DRY IRONING
32 If you’re dry ironing for 20 minutes or more, empty the reservoir.
33 Set the steam control to S.
34 Wait till the thermostat light goes out, then start ironing.
C VERTICAL STEAMING (#6)
35 Remove wrinkles from clothes, curtains, and furnishing fabrics.
36 Check there’s ventilation behind the fabric, or mildew may form.
37 Check nothing behind the fabric could be damaged by steam.
38 Check that pockets, turn-ups, and cuffs are empty.
To Next Page
Loading...
Need help?
General
