Russound CA-LCD2 User Manual

CONNECTION DIAGRAMS FOR RUSSOUND
®
MODEL CA-LCD2. REFER TO THE INSTRUCTIONS ON BACK. DIAGRAMS ARE NOT TO SCALE.
REMOTE SENSOR
VOLUME
SOURCE
STORE POWER
DIRECT ACCESS
NUMERIC SOURCE KEYPAD
897
564
2
31
0
ENTER
DIRECT SOURCE CONTROL
SEEK
MODE
SELECT
SCAN
REMOTE SENSOR
VOLUME
SOURCE
STORE POWER
4
IR
GND
+12V
CH SEL
SEL3
SEL1
BAL
VOL
IR
GND
+12V
CH SEL
SEL3 SEL1
BAL
VOL
BROWN
GREEN
ORANGE
BLUE
L
+
L
–
R
–
R
+
L
+
L
–
R
–
R
+
KEYPAD PORTS
123
12345678
CA-LCD2 REAR
SRM-2.1 REAR
a) Display
b) Source
c) Volume Up/Down
d) Lamp
e) Store
f) Power
g) IR receiver
h) IR confirmation LED
Green Brightness
Amber Brightness
Volume
Balance
Less More
When wiring directly to Amplified Module,
use T568A RJ45 wire configuration
110 punchdown connectors on CA-LCD2
110 punchdown connectors
on CA-LCD2
RJ45 Wall Plate
(optional) located
near Hub
Amplified zone input from
Russound
®
multi-zone system
Amplified
output to
in-wall
speakers
CAT-5 cable
RJ45 CAT-5 patch cable
Optional DSC and DAN Keypads dock easily
CA-LCD2 DSC DAN
Wire order
BROWN
GREEN
ORANGE
BLUE
1
2
2
6
5
7
GREEN
ORANGE
BLUE
ORANGE
BROWN

Russound CA-LCD2 Specifications

General

Display Type	LCD
Current Draw	50mA
Display	Backlit LCD
Communication	RS-232
Weight	0.5 lbs
Type	Keypad
Compatibility	Russound Multi-room Systems
Features	Backlit LCD, volume control, source selection
Wiring	CAT5/6
Buttons	8
Dimensions	4.5" x 2.75" x 1.375 inches

Summary

Wiring at the Controller

Punchdown Terminals

Clean Installation

Installing the Keypads

SRM-2.1

CA-LCD2 Keypad Operation

Display

The LCD panel displays the selected source and the volume level.

Source

Button to select one of the four sources; displays selection on LCD panel.

Volume Up/Down

Arrows adjust volume level and select source names after pressing store.

Lamp

Button controls backlight; hold to switch between amber and green colors.

Store

Function to select and store one of 23 preset source names for each source.

Power

Button turns the zone on or off, selecting previous source and minimum volume.

IR receiver

Receives commands from IR remote controls and passes IR to source equipment.

IR confirmation LED

LED flashes to confirm reception of an IR signal from a remote control.

CA-LCD2 Overview

CA-LCD2 Features

Setting the Keypad

Caution

Important Safety Instructions

CA-LCD2 Specifications

Limited Warranty