BURNERS
FREQUENTLY ASKED QUESTION
Why is there no seal between the burner and valve?
Answer: In order for the gas to get the right combustion at the burner, it must be mixed
with oxygen. This happens in the joint between the valve and the burner. The joint must
not be sealed. If you do, the combustion will deteriorate.
LIGHTING INSTRUCTIONS
1. Make sure all the burners are in the o position.
2. Connect the regulator to the gas cylinder. Open the gas cylinder’s valve to release
the gas.
3. Press the knob with a lightning symbol on the pizza oven and turn it anticlockwise
towards the HI position. This releases the gas and generates a spark.
4. If the burner does not light within 5 seconds, turn the knob to the closed position and
close the valve on the gas cylinder. Wait 3 minutes, and then redo steps 2 and 3.
5. Preheat the pizza oven 10 to 15 minutes before cooking.
6. Turn the knob between HI and LO to adjust the heat.
7. To switch it o, turn the gas cylinder’s valve to the closed position and then turn the
knob on the pizza oven clockwise to the closed position.
CARE AND CLEANING
• Allow the pizza oven to cool down before cleaning.
• Check to make sure the fuel supply from the LPG cylinder has been turned o.
• You must regularly clean the pizza oven of any fat/oil. If you do not, there is a high risk
of the fat starting to burn.
• Clean the interior and exterior of the pizza oven thoroughly and regularly.
• If the pizza oven is used in especially corrosive environments, for example, by the sea,
it is even more important to clean the pizza oven often. Salt and moisture will break
down the protective outer layer of the pizza oven, which can result in surface rust.
Valve
Burner hose
Gas
Oxygen
6
IM_623514760101_623514760102_Pizza_oven_v5.indd 6IM_623514760101_623514760102_Pizza_oven_v5.indd 6 2021-12-22 09:122021-12-22 09:12
To Next Page
Loading...
Need help?
General
