TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES ACTIONS
The burner
will not light.
The valve on the gas
cylinder is closed.
Open the valve on the gas cylinder.
The gas cylinder is
almost empty or empty.
Refill the gas cylinder.
There are no sparks
coming from the pin
alongside the burner
for ignition.
Check that the cables to the pin are
correctly connected.
Check that the pin alongside the burner is about
2–3 mm from the edge of the burner and is
directed towards the burner. If the pin is too
far from the burner, there will be no spark for
ignition. If the pin is too close to the burner, the
spark may be too small for ignitron.
The burner or valves are
blocked by fat, dirt or
insect netting.
Clean the burner and valves with compressed
air and pipe cleaners.
Check that the holes in the edge of the burner
are not blocked by fat.
The temperature
of the pizza oven
is low.
Too short warm-up time. Close the lid and turn the knob to “high”.
The gas is blocked. Check that there are no leaks. See the section
entitled “CHECKING FOR LEAKS”.
Check that the rubber washer on the gas
cylinder is intact.
Check that there are no kinks in the gas hose.
Clean the burners.
It is windy. Position the pizza oven sheltered from the wind.
9
SEENG
IM_623514760101_623514760102_Pizza_oven_v5.indd 9IM_623514760101_623514760102_Pizza_oven_v5.indd 9 2021-12-22 09:122021-12-22 09:12