Rutland 913 Windcharger Owner’s Manual
Document SM-130 Issue G 26.10.06 4 Marlec Engineering Co Ltd
CHECK YOU HAVE RECEIVED
• 24 x No. 10x25mm special self-tapping screws
• 1 x fuse and fuse holder
• 1 x main generator assembly
• 6 x aerofoil blades
• 1 x nose cone + 3 x nylon fixing screws
• 1 x 6mm Allen key
• 1 x 2-way terminal block
• 2 x M10 buttoncap screws
• 2 x shakeproof washers
• HRS913 Regulator (USA “Mariner’s Package” only)
• 600mm (23 ½”) Stainless Steel Tube (USA “Mariner’s Package” only)
In the event of loss or damage, consult your dealer or the manufacturer.
WHAT YOU WILL NEED
Tools
• Suitable wire stripper
• Small terminal screwdriver
• Large flat blade screwdriver
• Crosshead screwdriver
Other Items You Will Need
• Mounting pole
• Cable
• Batteries
• Battery terminals
• Connector blocks (as determined by your total system)
Other Items You May Have Selected
• HRS913 Regulator or HRDX Charge Controller
• Cable
• Rutland 913 Marine Mounting Kit (Part No: CA-12/02)
• Rutland 913 Land Tower & Rigging Kit (Part Nos: CA-12/08 & CA-12/07)
• Short section of stainless steel tube to adapt into your own mounting design.
• Voltmeter & Ammeter
To Next Page