To Next PageTo Next PageWhat to do if my Ruud 801P Furnace has an unexpected flame?
If your Ruud Furnace experiences an unexpected flame, examine the gas supply and manifold pressure to ensure they are within the correct parameters.
How to determine if my Ruud Furnace needs an isolation relay?
If you suspect that the Ruud Furnace may need an isolation relay, refer to the installation instructions under the section titled 'Isolation Relay' for detailed guidance.
What to do if my Ruud 801P Furnace has low flame sense?
If the Ruud Furnace experiences low flame sense, take the following steps: * Ensure there isn't excessive wind that could open the pressure switch. * Check for intermittent pressure switch operation. * Inspect switches and hoses for any signs of water or moisture. * Verify the gas supply and manifold pressure.
What to do if the pressure switch is stuck closed on my Ruud Furnace?
If the pressure switch on your Ruud Furnace is stuck closed when it should be open, check the pressure switch itself, the pressure switch hoses, and the wiring.
What to do if the pressure switch is stuck open on my Ruud Furnace?
If the pressure switch on your Ruud Furnace is stuck open when it should be closed, check the pressure switch itself, the pressure switch hoses, and the wiring.
Identifies and labels the various parts of the furnace.
Outlines critical warnings and precautions for safe operation and installation.
Guidelines for choosing an appropriate location and required clearances.
Instructions for connecting ductwork in upflow and horizontal configurations.
Requirements for combustion air supply and furnace venting systems.
Guidelines for gas connections and electrical wiring.
Details optional accessories that can be installed in the field.
Procedures for twin furnace installations and high altitude adjustments.
Steps for starting the furnace and timing diagrams for operation.
Configuration, airflow checks, blower speed, and input rate adjustments.
Explains diagnostic codes, lockout types, and troubleshooting steps.
Recommendations for filter cleaning, inspections, and part replacement.
Methods for diagnosing problems and the furnace's wiring schematic.
General
