4
CBL1802LBC
Motor 18 V DC
Air Velocity 190 km/h
Measured sound
pressure level
L
PA
:83 dB(A), K
PA
:2 dB(A)
Measured sound
power level
L
WA
:93.7 dB(A), K
WA
:2 dB(A)
Vibration ah:1.57 m/s
2
, K:1.5 m/s
2
Weight with
Battery Pack
1.9 kg
Battery Pack 1 x BPL-1815
Compatible
Battery Packs
ABP1801 / ABP1802 /
BPL-1815 / BPL-1820 /
BPL-1820G
Charger 1 x BCL1418
Compatible
Chargers
ACR-1800
(only for ABP1801 / ABP1802)
BCL-1800 / BCL-1800G /
BCL1418
(for all Compatible Battery Packs)
1. Blower housing outlet
2. Power switch
3. Blower tube
4. Latches.
5. Battery pack
See Figure 1.
The safe use of this product requires an understanding
of the information on the blower and in this operator’s
manual as well as a knowledge of the project you are
attempting. Before use of this product, familiarize yourself
with all operating features and safety rules.
The blower tube can be installed on the blower without
using any tools.
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the blower when assembling parts.
See Figure 2.
With the logo area facing up, slide the blower tube
over the outlet on the blower housing.
Press down on the tab on the blower housing outlet.
Push tab on outlet on the blower housing down until
it locks into place through the opening in the blower
tube.
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufcient to inict serious injury.
You may use this tool for the purposes listed below:
Clearing hard surfaces such as driveways and
walkways.
Keeping decks and driveways free from leaves and
pine needles.
Not intended for use other than what's listed above.
See Figure 3.
Place the power switch in the OFF ( O ) position.
Place the battery pack in the blower. Align raised rib on
battery pack with groove in the blower’s battery port.
Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
blower before beginning operation.
To Next Page
Loading...
