Page 6
SPECIFICATIONS:
CID1442P
10mm Keyless
14.4V DC 700
Variable Speed
0 - 350 RPM (Low)
0 - 1250 RPM (High)
0 - 400 RPM (Low)
0 - 1400 RPM (High)
0 - 5600 BPM (Low)
0 - 20000 BPM (High)
0 - 6400 BPM (Low)
0 - 22400 BPM (High)
24 Positions
240V, 50 Hz, AC Only
Chuck
Motor
Switch
No Load Speed
Impact Speed
Clutch
Charger Input
Charge Rate
3-6 Hours
CID1802P
10mm Keyless
18V DC 700
Variable Speed
24 Positions
240V, 50 Hz, AC Only
1 Hour
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "Charging
Your Impact Drill-Driver" for normal recharging of batteries. If the
charger/charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charger/charging assembly to your nearest Ryobi
Authorized Service Center for electrical check.
The operation of any power tool can result in foreign objects being thrown into your
eyes, which can result in severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and a full face shield
when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields.
WARNING:
To Next Page
Loading...
