4
GENERAL SAFETY RULES
Use battery operated tool only with specifically
designated battery pack. Use of any other batteries
may create a risk of fire. Use only with battery pack
supplied.
Do not abuse the supply cord (if fitted).
Never
carry the tool by the cord or yank it to disconnect
it
from the socket. Keep the cord away from heat, oil
and
sharp edges.
ACCESSORIES: Only use accessories that are
recommended
by the manufacturer of your model.
Acc
essories that may be suitable for one tool may
create a risk of injury when used on another tool.
WARNING
The
use of any accessories or attachments,
except
those recommended in this instruction
manual
and from other recognised accessory
suppliers, may present a risk of personal injury.
Ensure the battery pack is correct for the tool.
Ensure the outside surface of battery pack or tool is
clean
and dry before plugging into charger.
Ensure
that batteries are charged using the correct
charger recommended by the manufacturer, incorrect
use may result in risk of electric shock, overheating or
leakage of corrosive liquid from the battery.
Have your tools repaired by a qualified person.
This tool is manufactured in accordance with the
relevant safety requirement. Repairs should only be
carried
by qualified persons using original spare
parts
otherwise this may result in considerable
danger to the user.
If under abusive conditions, liquid is ejected from
the battery, avoid contact. If this accidentally
occurs,
flush with water. If liquid contacts eyes
additionally, seek medical help.
SPECIFIC SAFETY RULES
To reduce the risk of electric shock, unplug
charger from outlet before attempting any
maintenance
or cleaning. Turning off controls will
not reduce this risk. Following this rule will reduce the
risk of electric shock, fire or serious personal injury.
Disconnect charger from power supply when not
in
use. Following this rule will reduce the risk of
electric shock, fire or serious personal injury.
DANGER
RISK
OF ELECTRIC SHOCK. DO NOT TOUCH
UNINSUL
ATED PORTION OF OUTPUT
CONNECTOR OR UNINSULATED BATTERY
TERMINAL.
Save these instructions. Refer to them frequently
and
use them to instruct others who may use this tool.
If
you loan someone this tool, loan them these
instructions
also. Following this rule will reduce the
risk
of electric shock, fire or serious personal injury.
SERVICE: Now that you have purchased your tool,
should a need ever exist for repair, parts or service,
simply contact your nearest Ryobi Authorized Service
Center or call Ryobi customer service on 1300 361 505.
SPECIFICATION
Motor 4.8 Volts DC
Colle
t 6.35 mm
No Load Spee
d 330 min-
1
Switch Forward and Reverse
Maximum
Torque 5.64 Nm
Charger Ratin
g 240 V ~ 50 Hz 4 W
Charge
Time 5 - 8 hours
UNPACKING INSTRUCTIONS
Your screw driver has been shipped completely assembled.
Carefully remove the screw driver, and accessories
from
the box. Make sure that all items listed in the
packing list are included.
Inspect the screw driver carefully to make sure no
breakage or damage has occurred during shipping.
Do not discard the packing material until you have
carefully
inspected and satisfactorily operated the tools.
PACKING LIST
-
- Bits
- Charger
- Operator's Manual
WARNING
If
any parts are missing, do not operate this tool
until
the missing parts are replaced. Failure to do
so
could result in possible serious personal injury.
To Next Page
Loading...
