To Next Page
R
Roberta CastroAug 6, 2025
What to do if Ryobi Brush Cutter cutting head will not advance line?
- NnathanharringtonAug 6, 2025
If the cutting head of your Ryobi Brush Cutter isn't advancing the line, try these solutions: refill the cutting head with a new line, replace the inner reel if it's bound up or if the indexing teeth are worn or burred. Clean the inner reel and outer spool if the cutting head is dirty. If the line is welded, disassemble, remove the welded section, and rewind the line. Disassemble and rewind the reel if the line was twisted during refill. If not enough line is exposed, push the Bump Knob and pull out 102 mm of line until the line is outside of the cutting head.
General
