2
English
e. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tools operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits
etc., in accordance with these instructions and
in the manner intended for the particular type
of power tool, taking into account the working
conditions and the work to be performed. Use
of the power tool for operations different from
intended could result in a hazardous situation.
5. SERVICE
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
SPECIAL SAFETY RULES
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
This appliance is not intended for use by young
children or infirm persons. Adequate supervision by a
responsible person must be provided to ensure that
they do not play with the appliance.
Keep children and visitors away. Visitors should
wear safety glasses and be kept a safe distance from
work area. Do not let visitors contact tool or extension
cord.
Complies with AS/NZS 60745.
Recommended for the use of a residual current device
with a rated residual current of 30 mA or less.
SPECIFIC SAFETY INSTRUCTIONS FOR
SANDERS
Always wear safety goggles and a dust mask when
sanding, especially sanding over-head.
The machine is not suitable for wet sanding.
Do not use sanding paper larger than needed.
Extra paper extending beyond the sanding pad can
also cause serious lacerations.
The dust box shall be equipped with the tool. It should
be emptied frequently. To connect dust box, insert the
adaptor of dust box to the dust-collection opening on the
rear end of the sander.
WARNING
Do not throw sanding dust on an open fi re because
materials in fi ne particle form may be explosive.
WARNING
A suitable breathing respirator must be worn while
sanding lead paint, some woods and metal to avoid
breathing the harmful/toxic dust or air.
SPECIFICATIONS
Voltage 230 V - 240 V 50 Hz
Power 80 W
Orbital minute 12000 min
-1
Weight 0.95 kg
FEATURES
KNOW YOUR COMPACT FINISHING SANDER
See Figure 1.
Before using this product, familiarize yourself with all
operating features and safety requirements. However, do
not let familiarity with the tool make you careless.
SWITCH
This tool is equipped with a simple switch control located
near the front of the motor housing.
QUICK CHANGE HOOK AND LOOP PAD
The hook and loop design allows for quick change of
sanding sheets. It also enables you to easily clean and
reuse them.
CIRCULAR SANDING ACTION
The oscillating action of your sander produces very quick,
small circular motion of the sanding pad. The motion is
ideal for producing a fi ne fi nished grain.
DUST COLLECTION BOX
The dust box attaches to the sander and keeps dust to a
minimum.
To Next Page
Loading...
