Ryobi OLT1832 - MAINTENANCE: REPLACING THE SPOOL; Removing spool cover and spool; Threading cutting line

16
MAINTENANCE
REPLACING THE SPOOL
1. Press the latches on the battery pack to
remove the battery pack.
2. Press the tabs on the sides of the spool
retainer. Remove the spool cover and the
spool.
3. Thread the cutting line through the eyelet.
Install the spool.
NOTE: Ensure that the cutting line and slot
are aligned with the eyelet.
4. Attach the spool cover until the latches click
into place.
1
2
1
3
2
2
1
1
2
3
4