To Next PageTo Next Page
Need help?Do you have a question about the Ryobi P4003 and is the answer not in the manual?
General| Type | String Trimmer |
|---|---|
| Power Source | Battery |
| Voltage | 18V |
| Battery Type | Lithium-ion |
| Line Diameter | 0.065 inches |
Keep work area clean and well lit. Do not operate in explosive atmospheres. Keep children and bystanders away.
Match plugs to outlets. Avoid earthed surfaces. Do not expose to rain or wet conditions. Handle cords with care.
Stay alert, use common sense. Wear eye protection and PPE. Prevent unintentional starting. Do not overreach. Dress properly.
Use the correct tool for the job. Ensure the switch works. Disconnect power before adjustments. Store out of reach of children.
Recharge only with specified charger. Use only designated battery packs. Keep away from metal objects. Avoid damaged batteries.
Have tool serviced by qualified personnel using identical replacement parts. Never service damaged battery packs.
Use GFCI protected cords. Grasp cable with gloves. Do not stop cutter while cable turns. One person controls cable and switch.
Use latex/rubber gloves, goggles, face shields, protective clothing, and respirator when dealing with hazardous substances.
Practice good hygiene. Do not eat or smoke. Wash hands after use. Use appropriate drain cleaner sizes. Wear safety goggles.
Position auger within 2 feet. Avoid running clockwise for extended periods. Keep hands away from rotating parts.
Battery tools are always in operating condition. Keep away from fire/heat. Do not crush or drop battery packs. Batteries can explode.
Do not charge in damp locations. Avoid extreme temperatures. Handle battery leakage with soap and water or clean water.
Connect to 120V AC, 60 Hz power supply. Do not use DC. Check voltage drop.
Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit or outlet.
Use 3-wire grounded cords with correct wire gauge. Use outdoor-rated cords. Inspect cords for damage. Arrange a drip loop.
Explains Danger, Warning, Caution, and Notice signal words and their associated risk levels.
Explains symbols like Safety Alert, Read Operator's Manual, Eye Protection, Wet Conditions, Wear Gloves, Long Hair, Loose Clothing, Recycle.
Explains symbols for Volts, Amperes, Hertz, Watt, Minutes, Direct Current, Alternating Current, Per Minute, and Class VI Tool.
Details cable diameter, length, power source, minimum/maximum pipe size, and no-load speed.
Use for clearing obstructions from plumbing drains.
Steps to open the compartment, insert, and secure the battery pack.
Steps to connect and disconnect the power supply cord. Routing precautions.
How to set the selector for clockwise, counterclockwise, or off rotation.
How to use the dial to adjust speed for different tasks like feeding or agitating.
Steps to feed the cable into the drain and retract it using the tension knob.
Instructions for attaching and detaching different types of auger tips.
Guidance on clearing obstructions, including P-trap removal and cable feeding.
Steps for draining the drum and cleaning the cable after use.
Avoid solvents on plastic parts. Use clean cloths. Keep away from brake fluids and petroleum products.
Instructions for replacing a worn auger tip. Refer to earlier section.
Steps to replace the drum if the cable is damaged or broken.
