12
OPERATION
Fig. 4
Fig. 5
TO INSTALL BATTERY PACK
See Figure 4.
Place the battery pack on the tool.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured on the
tool before beginning operation.
TO REMOVE BATTERY PACK
See Figure 4.
Depress the latches on the side of battery pack.
Remove the battery pack from the tool.
SANDING DISC SELECTION
Selecting the correct size grit and type sanding disc is an
extremely important step in achieving a high-quality sanded
finish. Aluminum oxide, silicon carbide, and other synthetic
abrasives are best for power sanding. Natural abrasives,
such as flint and garnet are too soft for economical use in
power sanding.
In general, coarse grit will remove the most material and finer
grit will produce the best finish in all sanding operations. The
condition of the surface to be sanded will determine which
grit will do the job. If the surface is rough, start with a coarse
grit and sand until the surface is uniform. Medium grit may
then be used to remove scratches left by the coarser grit and
finer grit used for finishing of the surface. Always continue
sanding with each grit until surface is uniform.
ATTACHING HOOK-AND-LOOP SANDING
DISC
See Figure 5.
To attach hook-and-loop sanding disc:
Remove battery pack from sander.
Align the holes in the sanding disc with the holes in the
hook-and-loop backing pad.
Press the sanding disc against the backing pad as firmly
as possible.
NOTE: To provide for the best adhesion, we recommend
that you clean the backing pad and the sanding disc
backing occasionally by brushing them lightly with a small
brush.
HOOK-AND-LOOP
SANDING DISC
BACKING PAD
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
BATTERY
PACK
To Next Page
Loading...
