32 - English
TROUBLESHOOTING
CALL US FIRST
For any questions about operating or maintaining your product,
call the Ryobi
Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
Problem Possible Cause Solution
Bar and chain run-
ning hot and smok-
ing.
Check chain tension
for over tight condition
Chain oil tank empty.
Tension chain. Refer to Adjusting Chain Tension
earlier in this manual.
Check oil tank.
Motor runs, but chain
is not rotating.
Chain tension too
tight.
Check guide bar and
chain assembly.
Check guide bar and
chain for damage.
Retension chain, Refer to Adjusting Chain Tension
earlier in this manual.
Refer to Replacing Bar and Chain earlier in this manual.
Inspect guide bar and chain for damage.
Motor runs, chain
rotates but does not
cut.
Dull chain.
Chain on backwards.
Sharpen chain.
Reverse direction of chain.
Chain tension adjust-
ment ring is difficult
to turn.
Tip of guide bar is not
raised.
Chain cover lock knob
is too tight.
Raise tip of guide bar while rotating tension adjust-
ment dial.
Press in the chain cover lock knob and rotate coun-
terclockwise to slightly loosen the chain cover before
attempting to adjust chain tension.
This product has a Three-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
or call (toll free) 1-800-860-4050.
To Next Page
Loading...
