7 — English
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
STORAGE
Allow the glue gun to cool completely before storing. Turn the
switch to the off (O) position and remove the battery pack.
WARNING:
Always remove the battery pack before storage to ensure
the product is off. Allow a minimum of 30 minutes of
cool-down time before storage. Storing a glue gun with
a hot nozzle can cause serious burns and/or ignite com-
bustible objects.
To help prevent drips and clogs the next time the glue gun
is used, remove dried glue from the nozzle area.
MAINTENANCE
When the desired amount of glue has been applied, re-
lease the trigger. Tilt the nozzle slightly to the side and
carefully pull the nozzle away from the object. This helps
avoid strings of glue clinging to the work.
NOTE: The glue gun will stop dispensing glue when the glue
stick in the chamber is almost used up. To refill the chamber,
set the glue gun down and insert another glue stick.
Always turn the on/off switch to the off (O) position when
you are finished using the glue gun. Set the glue gun on
a protective surface, such as a piece of paper, while the
product cools to catch possible glue drips.
Allow the glue stick and glue gun nozzle to completely
cool before removing the battery pack, and before stor-
age.
OPERATION
To Next Page
Loading...
