4
SYMBOLS
Important: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the tool better and more safely.
SYMBOL NAME EXPLANATION
Safety Alert Symbol Indicates danger, warning or caution. It means
attention!!! Your safety is involved.
Read Your Operator’s Manual Your manual contains special messages to bring
attention to potential safety concerns as well as
operating and servicing information. Please read all
the information carefully to ensure satisfaction and
safe use.
Wear eye and hearing protection Wear eye and hearing protection when operating this
equipment.
Keep bystanders away Keep all bystanders at least 15 m (50 ft) away.
Ricochet Danger of Ricochet.
No blade Do not install any type of blade on this unit.
RPM Decal Rotational direction and maximum speed of the shaft
for the cutting attachment.
Boots Wear non-slip safety footwear when using this
equipment.
Gloves Wear non-slip, heavy-duty gloves.
No Smoking Do not smoke when mixing fuel or filling fuel tank.
Petrol Use unleaded petrol intended for motor vehicle use
with an octane rating of 87 ([R + M] / 2) or higher.
Oil Use 2-cycle oil for air cooled engines.
Mix Petrol and Oil Mix the fuel mix thoroughly and also each time before
fuelling.
Switch On/Off Switch
I = ON to Run
O = OFF to Stop
min
-1
9,000
To Next Page
Loading...
Need help?
General
