13
OPERATION
1
1
2
ADJUSTING THE DEPTH OF CUT
1. Remove the battery pack.
2. Move the depth adjustment lever up to
increase the depth of cut, or down to
decrease the depth of cut.
NOTE: The depth adjustment lever locks into
one of four positions.
NOTE: Adjust the blade depth from 15 mm (0.59
in.) to 45 mm (1.77 in.) deep initially. Make a
shallow cut to test the cutting depth. If the cutting
depth needs adjusting, do this progressively
until the preferred depth is reached.
NOTE: The angle in which the product is
positioned affects the exact depth of cut.
To Next Page
Loading...
